Muhammad Afnan Habibi, Langlang Gumilar, Arya Kusumawardana, Mahfud Jiono, Soraya Norma Mustika, Arif Nur Afandi
There are several wireless technologies that have been built to move energy to a very wide array. Power transfer may be performed at a lower frequency than the described ones. The adjustments not only supported power transmission inside the high unit, but also included certain control mechanisms. Those works did not recognize the overall angular frequency output. This paper's outcome, which cares about machine performance, gives the method which is higher than those tests. This research looks at a capacitive load circuit inside a wireless network. Available angular frequencies below 12 kilorad/s may be provided to the wireless network for the capacitive load. Selection depends on how much power the charge absorbs and how much the performance of the device is required. The approximation outcome at angular frequency ω = 3003.5 rad/s is power input Sin = 0.3328 mVA, and power output Sout = 0.3178 mVA. Even experiencing small amount of power loss, this frequency barely has enough capacity to pass to the load. Then, it adds the next ω = 2572.27 rad / s. This frequency generates Sin = 8.9684 mVA, and Sout = 8.0924 mVA. It can be admitted that both current input and output are growing larger than the first one. Another ω = 8305.34 rad/s is the last frequency setting. Sin and Sout will be 40.7964 mVA and 31.0623 mVA. This system is still considerable when a high demand for power is required for the wireless load and the system efficiency is acceptable. © 2020 IEEE.
Universitas Negeri Malang, Department of Electrical Engineering, Malang, Indonesia
