P. Adinegoro, H. Ali, Saparullah, Sunaryono, Aripriharta, N. Mufti
This paper reports the performance of the flexible nanogenerator as a green energy harvester depends on connection variation. The ZnO nanogenerator was successfully fabricated on Al/PET. The ZnO Nanorods were synthesized using a hydrothermal method at 95°C. The ZnO Nanorods were characterized using X-ray diffraction (XRD), scanning electron microscopy (SEM), fourier transforms infrared spectroscopy (FTIR), and UV-Vis spectrophotometer. The performance of the nanogenerator was performed using Osiloscop and electrometer in series and parallel connection. Based on the XRD pattern, ZnO sample has a hexagonal (wurtzite) crystal structure in which the lattice parameters of a = b, and c = 3.258 Å, and 5.218 Å, respectively. The morphology of ZnO is a hexagonal form with diameters of 81,06 nm to 467.69 nm and rod length around 595 nm to 1331 nm. Based on the FTIR spectra, there are Zn-O bonds at 435-445 cm-1, 535 cm-1 and, 541 cm-1. Moreover, ZnO nanorods have an energy gap band of 3.2 eV. The performance of the ZnO nanogenerator in series form has the highest voltage with a value of 10.36 volts AC, and the voltage value in dual-source is more than ten times larger compared to a single source. © Published under licence by IOP Publishing Ltd.
Department of Physics, Faculty of Mathematics and Natural Sciences, State University of Malang, Jl. Semarang No.5, Malang, 65145, Indonesia; Department of Electrical Engineering, Faculty of Engineering, Universitas Negeri Malang, Malang, 65145, Indonesia; Center of Advanced Materials for Renewable Energy, Universitas Negeri Malang, Jl. Semarang No.5, Malang, 65145, Indonesia
