Wahono Wahono, Arnanda Irfan, Suyetno Agus, Aminnudin Aminnudin, Saad Ansari Abu, Rohmat Aji Pradana Yanuar
This research was conducted to investigate the effect of variations in tool rotation and surface roughness towards shear strength on the newly developed friction lap welding (FLW) for dissimilar joints between stainless steel (SS) 304 and Nylon 6 plates. Under constant welding traverse speed at 30 mm/min, the variation of tool rotation used were 1100 and 2200 rpm and surface roughness of 0.32; 1.25; and 1.88 µm initially obtained from different surface modification methods. The shear test was conducted at FLW dissimilar joint based on AWS D8.9-97 standard. The results showed that the shear stress increased along with the higher tool rotation and at the greater surface roughness. The highest shear strength value was found at the tool rotation of 2200 rpm and surface roughness of 1.88 µm with 9.447 MPa. The tool rotation may produce a higher heat input as well as an effect on the value of nylon hardness. On the other hand, rougher SS surfaces provide a larger area for the interfacial adhesive bond between nylon and metal; therefore, they can act as an interlocking site when the shear loading was applied. These phenomena were also confirmed by fracture morphology and microscopic image analysis. © 2023 Trans Tech Publications Ltd, Switzerland.
Department of Mechanical Engineering, Universitas Negeri Malang, Indonesia; Materials Science and Engineering, Incheon National University, South Korea